Spot-weld thickness ratio <= 3:1 and contact width for the electrode on a detected lap joint.
No standards reference is assigned to this check. The scope described above applies.
Sheet metal · CC0-1.0
Model example
Two 2 mm plates overlap by only 6 mm. A spot-weld electrode tip needs a contact width of more than 8 mm.
Dimensions (approx.): 114 × 30 × 4 mm
PRU-106 should warn (worded: if spot welded) that the 6 mm overlap is below 8 mm and nothing else.
Finding expected
Sheet metal · CC0-1.0
Model example
The same lap with a 20 mm overlap and a 2 mm / 3 mm thickness ratio (1.5:1).
Dimensions (approx.): 100 × 30 × 5 mm
PRU-106 must stay silent: the overlap is wider than 8 mm.
No finding expected