Sheet metal · Laser cutting · Plasma cutting · Flame cutting
Inside corner radius smaller than half the laser kerf (0.075 mm); sharp (r = 0) corners are not flagged because the laser rounds them automatically. Source: GL-Laser; teprosa.de for kerf.
No standards reference is assigned to this check. The scope described above applies.
Laser cutting · CC0-1.0
Model example
A 30 × 15 mm window whose four corners carry a 0.04 mm radius. A laser beam is about 0.15 mm wide, so a corner radius below half the kerf (0.075 mm) cannot be cut as drawn; the beam rounds it.
Dimensions (approx.): 100 × 60 × 3 mm
PRU-085 should warn about the corner radius below half the kerf and nothing else.
Finding expected
Laser cutting · CC0-1.0
Model example
The same window with 2 mm corner radii, well above half the kerf.
Dimensions (approx.): 100 × 60 × 3 mm
PRU-085 must stay silent: the 2 mm corner radius is far above half the kerf.
No finding expected