Machining
Flag holes where depth/diameter > 5:1 (chip packing & drill wandering risk).
No standards reference is assigned to this check. The scope described above applies.
Machining · CC0-1.0
Model example
Look through the central Ø4 mm bore in the 40 × 40 × 8 mm block. Axial depth/diameter = 2; the deep-hole heuristic warns above 5. Rotation must not change it.
Dimensions (approx.): 40 × 40 × 8 mm
Compare: Ø4 through hole: 40 mm deep
Machining · CC0-1.0
Model example
Look through the central Ø4 mm bore in the 40 × 40 × 40 mm block. Axial depth/diameter = 10; the deep-hole heuristic warns above 5. Rotation must not change it.
Dimensions (approx.): 40 × 40 × 40 mm
Compare: Ø4 through hole: 8 mm deep
Machining · CC0-1.0
Model example
Look through the central Ø4 mm bore in the 40 × 40 × 40 mm block. Axial depth/diameter = 10; the deep-hole heuristic warns above 5. Rotation must not change it.
Dimensions (approx.): 66.909 × 58.324 × 59.931 mm
Compare: Ø4 through hole: 8 mm deep
Machining · CC0-1.0
Model example
Look through the central Ø4 mm bore in the 40 × 40 × 20 mm block. Axial depth/diameter = 5; the deep-hole heuristic warns above 5. Rotation must not change it.
Dimensions (approx.): 40 × 40 × 20 mm
Compare: Ø4 through hole: 40 mm deep
Machining · CC0-1.0
Model example
This 40 mm long Ø4 cylinder has closed end faces and solid material inside. It is a shaft, not a 10:1 deep hole.
Dimensions (approx.): 4 × 3.97 × 40 mm
PRU-009 must not report a deep-hole warning on an exterior cylinder.
No finding expected